Mercedes-Benz GLA Forum banner

1 - 11 of 11 Posts

·
Registered
Joined
·
66 Posts
Discussion Starter #1
Anyone install one in their vehicle? It installs in center vent bezel. Before I order one I would like to know how well it works before I spend a bunch of money on it. Thanks everyone.
 

·
Registered
Joined
·
5 Posts
Depends on what you are looking for in a gauge. If you only need 1 for boost or other, then the single pod is less$$ overall.

If you like the p3 with its many varied readouts that can be switched thru then it's worth the $$

I had one in my 2015 BMW 435 before going with the Awron vent gage and it was hi quality with perfect fitment obviously since its mounted in factory vent.

I never had a problem with it over couple years and was able to switch thru all the functions with steering wheel controls

Sold it for good $$ yrs later on BMW forum when going with Awron :D
 

·
Registered
Joined
·
80 Posts
Hello All,

Photo of the P3 Gauge installed into my GLA.

Happy to share any information that you want to know about it.
 

Attachments

·
Registered
Joined
·
444 Posts
Hello All,

Photo of the P3 Gauge installed into my GLA.

Happy to share any information that you want to know about it.
yah any good instructions would be good.
C
 

·
Registered
Joined
·
80 Posts
Easy to install ?
Wasn't too bad, a little more difficult being a right hand drive car as the layout behind the dash wasn't the same so needed to fiddle around with wiring. Should be easier for left hand drive cars as the gap to run cables can be seen easily.
 

·
Registered
Joined
·
80 Posts
yah any good instructions would be good.
C
There are instructions on the P3 Gauge website. Follow the A Class install.
 
1 - 11 of 11 Posts
Top