Mercedes-Benz GLA Forum banner
1 - 11 of 11 Posts

·
Registered
Joined
·
816 Posts
Nope…solid across entire width. Looks like a trip back to the dealer...
 

·
Registered
Joined
·
84 Posts
Mine are also like in the photo. Are you sure SSBGLA45 that the entire width must light up?
 

·
Registered
Joined
·
172 Posts
My brand new 2016 GLA 250 lights up in one solid band with no gaps.
 

·
Registered
Joined
·
84 Posts
Safety

Here in the adaptve brake lights session the break lights are shown as in my car...
 

·
Registered
Joined
·
816 Posts
Solid across>>>

 

·
Registered
Joined
·
84 Posts
Oh my bad, did not see that the op meant the "center" brake light. You are right, it should be solid across!
 

·
Registered
Joined
·
470 Posts
What I wish is that the tailights filled the whole lower part when braking (hope OP doesn't mind me re-using his pic)

This part not being filled with light looks off.




Would look way better if it lit up like this when breaking.

 

·
Registered
Joined
·
816 Posts
Is it possible to make it fully light up?
Not easily… the area in question is a reflector area (DOT requires so much (%) of the total area of the rear brake/turn signal assembly be reflective) so to have it light up would require rebuilding the rear brake housing including bringing in wiring etc.
 
1 - 11 of 11 Posts
Top