very nicely done, looks like an expert install. which piece was most difficult to install?
Carbon Fiber impressions - Interior
10
So I decided to be the guinea pig for the CarID interior kit.
Overall, very pleased. However, I didn't set the bar real high...
It really is very nice, definitely real carbon fiber, and only one piece in the kit had a fitment issue.
I ended up only using about 30% of the whole kit, as it looked like absolute, tacky overkill with everything installed.
What I really liked, was all the great flexible pieces that molded around the steering wheel, dash and gauges.
Here's the few pieces i kept:
Overall, very pleased. However, I didn't set the bar real high...
It really is very nice, definitely real carbon fiber, and only one piece in the kit had a fitment issue.
I ended up only using about 30% of the whole kit, as it looked like absolute, tacky overkill with everything installed.
What I really liked, was all the great flexible pieces that molded around the steering wheel, dash and gauges.
Here's the few pieces i kept:
1 - 9 of 9 Posts
Thank you very much
I used a heat gun, which makes install much easier. I'd say the most difficult piece was the big piece that wraps around the whole armrest/console and cup holder. Fortunately, after I laid down half of it, I quickly realized it looked absolutely 'ridiculous' with all that carbon fiber, it looked worse. So I just kept the lids and the trim around the lids on the center console.You get a LOT of carbon fiber pieces in this kit, but honestly, you probably won't use a lot of it, some pieces are just absurd in intention.
1 - 9 of 9 Posts
